Circular vibrating screen is widely used for building materials, chemical, food, abrasives, plastic, medicine, chemical fertilizer, metallurgy, glass, food, ceramics etc.
The following are the methods to prolong the life span of circular vibrating screen which might give you some ideas during the operation:
1.The bolts which connected with the body and screen box of circular vibrating screen are strength bolts. It cannot be replaced by using normal bolts to connect with the body and screen box. The fastening of bolts must be checked regularly, at least once a month. Loosen of bolts might occur if any bolt is loosen, which will cause damage to linear vibrating screen.
2. The space between side plates and mesh sieve box must be equal during replacing the woven mesh. First of all, tighten up the flat steel in the middle. At the same time tighten the mesh surface tension and ensure the surface tension is uniform and constant. Then, slightly tap the mesh surface tension along the entire length by using a hammer to check the tension. One of the reasons for woven mesh to damage in shorter period is due to the tension, either not enough or uneven.
The following are the methods to prolong the life span of circular vibrating screen which might give you some ideas during the operation:
1.The bolts which connected with the body and screen box of circular vibrating screen are strength bolts. It cannot be replaced by using normal bolts to connect with the body and screen box. The fastening of bolts must be checked regularly, at least once a month. Loosen of bolts might occur if any bolt is loosen, which will cause damage to linear vibrating screen.
2. The space between side plates and mesh sieve box must be equal during replacing the woven mesh. First of all, tighten up the flat steel in the middle. At the same time tighten the mesh surface tension and ensure the surface tension is uniform and constant. Then, slightly tap the mesh surface tension along the entire length by using a hammer to check the tension. One of the reasons for woven mesh to damage in shorter period is due to the tension, either not enough or uneven.
3. The temperature of bearing should not exceed 75°C during normal operation. This is because there is a running-in process of new vibrator which might cause the higher temperature, but the temperature will be stable after running for 8 hours. Check the standard, oil level and purity of oil if the temperature remains high.
conveyor belting Distributor
回复删除